Ford Focus TCM adaptive learning with Launch X431 PRO3

launch-x143-Ford-TCM-adaptive-learning-1

This is the how-to’s of ‬TCM adaptive learning – clutch learning, applicable for all Ford models.

Upload images…

Select FORD

Launch X431 Pro3 comes with Ford series software V46.24

Confirm

Automatically Search

Ford Focus vehicle specification

System selection

TCM (transmission control module)

TCM system information

Special functions

TCM adaptive learning

Warning: the function will change the status of your vehicle

TCM adaptive learning:

This function allows the ECM to learn new parameters after component replacement, which must be performed as recommended in the service manual procedures.

This function will reset the TCM parameters and execute a series of rountines to allow th ECM to learn clutch, shift drum and TRS parameters.

If these functions are not performed as recommended, it will effect transmission operation and performance.

In some cases, the service manual may recommend.

Performing these functions to diagnose transmission components.

If there is a mechanical failure or electrical concern with the related system, the function may fail.

Ignition on

Clutch

Perform the function as recommended in the service manual procedures

Make sure that the transmission gear selector is in the PARK position

Depress the brake pedal and hold

Start to set the clutch parameter one by one

…

Start engine or crank for 5 seconds if engine does not start

Note: do not depress the throttle pedal

Make sure that the transmission gear selector is in the PARK position

Depress the brake pedal and hold

Press the accelerator pedal to the floor. So the engine reaches maximum speed during WOT (wide open throttle)

Clutch adaptive learning:

Return to idle.

Initiating the clutch touch point adaptive learn for clutches A and B.

Note: this function will attempt to learn the engagement travel of both clutches by engaging direct drive/overdrive gear ratios and progressively engaging both clutch elements. Engaging load is monitored while the touch point is in progress. It is critical that the brake pedal be held consistently and the engine load remain stable released of the brake pedal or varying engine load will result in adaptive learn failure.

It is recommended that the engine at operating temperature. The transmission must be in the PARK position and all vehicle electrical accessories must be turned off.

Note: it is critical that the AC conpressor is not active during the routine. In rare cases, mytouch equipped vehicles may automatically turn the HVAC system back to on. Stat following an ignition cycle. Make sure the HVAC is turned off before proceeding with touch point learn process. Depress the brake pedal and hold.